LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Transmission System (Gears & Shafts - Service Information - 6-Speed Manual - 02Q)) >> 35 Gears, Shafts >> Output Shaft >> Output Shaft, Disassembling And Assembling >> Output Shaft, 5TH, 6TH And Reverse Gears, Disassembling And Assembling >> Check the 5th and 6th Gear Synchronizer Ring for Wear

Check the 5th and 6th Gear Synchronizer Ring for Wear

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
GWWN35-10479Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
-A- = Brass Synchronizer Ring
Gap Dimension -a- Installation Dimension Wear Limit
5th and 6th gear 1.0 to 1.7 mm 0.5 mm
-B- = Steel Synchronizer Ring
Gap Dimension -a- Installation Dimension Wear Limit
5th and 6th gear 1.2 to 2.1 mm 0.8 mm

-- Press synchronizer ring onto taper of the gear wheel and measure gap dimension -a- using a feeler gauge.

GWWV35-0975Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
scientia non olet · About LEMON Manuals