Remove the Inner Race/Tapered Roller Bearing on the Side of the Transmission Housing
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
|
Note the following before installing the Tapered Roller Bearing Puller:
-- Remove the inner race/tapered roller bearing locking ring on the side facing the transmission housing.
-- Place the Press Piece - Multiple Use:VW431
in the output shaft and lay the Press Piece - Multiple Use:40-105
on top.