LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Transmission System (Gears & Shafts - Service Information - 6-Speed Manual - 02Q)) >> 35 Gears, Shafts >> Output Shaft >> Output Shaft, Disassembling And Assembling >> 1ST To 4TH Gear Output Shaft, Disassembling And Assembling >> Assembling the Locking Collar/Synchronizer Hub for 1st, 2nd, 3rd and 4th Gears

Assembling the Locking Collar/Synchronizer Hub for 1st, 2nd, 3rd and 4th Gears

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
GWWV35-0981Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The locking collar is pushed over the synchronizer hub.

-- Install the locking pieces and springs offset by 120°. The angled end of the spring must engage into the hollow locking piece.

scientia non olet · About LEMON Manuals