Checking Measurement
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- The selected adjusting shim is installed.
-- Attach the measuring tools to the clutch housing.
In the case of protruding housing edges:
-- Place washers (total thickness: 8 mm) under the :VW792 -arrow-.
-- Set the dial gauge (3 mm range) with 1 mm preload to "0".
-- Loosen securing bolts for clutch housing/transmission housing in diagonal sequence until bolts clear transmission housing and output shaft.
- For correctly selected adjustment shim, dial gauge must now display a value of 0.15 mm to 0.25 mm.