Driveshaft Flange Seal On Rear Final Drive, Replacing: Installing: Notes
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
-- Before installing, lightly lubricate the new seal at the outer diameter and between the sealing lips with All Wheel Drive Clutch Oil.
-- Drive in the new seal all the way using the :T10019 . Do not tilt the seal.
-- Install the driveshaft flange using the :30-20 .
-- Insert the new hex nut with Locking Compound and tighten. Refer to OVERVIEW - ALL WHEEL DRIVE CLUTCH .
A -M10 x 20 Hex Bolts
B -M8 x 15 Bolt (installed in the :3415 from the rear)
Install in reverse order of removal. Note the following:
-- Install all parts marked to each other in their original positions.