Right Flange Shaft Seal In Front Axle Differential Lock, Replacing: Removing
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove front axle differential lock. Refer to FRONT AXLE DIFFERENTIAL LOCK, REMOVING .
-- Secure the front axle differential lock to the engine and transmission holder. Refer to FRONT AXLE DIFFERENTIAL LOCK, SECURING TO ENGINE AND TRANSMISSION HOLDER .
-- Remove the flange shaft. Refer to Removing And Installing Flange Shaft.(VW771, Completing with VW540/1B.) .
The Seal Is Located in the Front Axle Differential Lock in Front of the Roller Bearing -A-.
CAUTION:
Do not damage the roller bearing -A- when removing the seal.
Seal installation position:
105 mm under the upper edge/hollow shaft
-- Pull out the seal using the :VW771 with :VW771/37 .
- Press the Slide Hammer Set - Hook: VW771/37 forcefully in the seal direction of -arrow-.