Overview - Exhaust Gas RECIRCULATION (EGR): Notes
WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
- EGR Cooler
- Removing and installing. Refer to EGR COOLER, REMOVING AND INSTALLING .
- Checking for leaks. Refer to EGR COOLER, CHECKING FOR LEAKS .
- Bolt
- Tightening specification and sequence (refer to EGR Cooler - Tightening Specifications and Sequences ), if only the exhaust gas recirculation cooler is removed
- Bracket
- For the EGR cooler
- Bolt
- Tightening specification and sequence (refer to EGR Cooler - Tightening Specifications and Sequences ), if only the exhaust gas recirculation cooler is removed
- Screw-Type Clamp
- Tightening specification and sequence. Refer to EGR Cooler - Tightening Specifications and Sequences .
- Always replace after removing.
- Seal
- Always replace after removing.
- Emissions Control Module
- Removing and installing. Refer to EMISSIONS CONTROL MODULE, REMOVING AND INSTALLING .
- EGR Valve 2 -GX6-
- With EGR Motor 2 -V339-
- With Exhaust Gas Recirculation Position Sensor 2 -G466-
- Overview. Refer to OVERVIEW - EXHAUST GAS RECIRCULATION (EGR) .
- Removing and Installing. Refer to EGR Valve 2 -GX6-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Seal
- Always replace after removing.
Installation Position of the Air Duct Hose on the EGR Cooler.