Work procedure

-- Connect the scan tool.

-- Start the engine and let run at idle speed.

-- Select Mode 6: Check test the results of components that are not continuously monitored.

Select the desired Test-ID.

The current minimum and maximum values will be displayed on the scan tool screen.

The following table is a numerical list of all "Test-IDs" that may be selected.

Monitor-ID	Component or System
$01: Monitor-ID $01: Oxygen Sensor Monitor Bank 1 - Sensor 1	Oxygen Sensor Monitor Bank 1 - Sensor 1
$02: Monitor-ID $02: Oxygen Sensor Monitor Bank 1- Sensor 2	Oxygen Sensor Monitor Bank 1 - Sensor 2
$21: Monitor-ID $21: Catalytic Converter Monitoring	Catalytic Converter Monitoring
$35: Monitor-ID $35: Camshaft adjustment / IVVT diagnosis bank 1	Camshaft adjustment / IVVT diagnosis bank 1
$3C: Monitor-ID $3C: Tank ventilation system leak test (0.020" / 0.5mm)	Tank ventilation system leak test (0.020" / 0.5mm)
$3D: Monitor-ID $3D: EVAP Valve Function Check	Tank vent valve - function check
$41: Monitor-ID $41: Oxygen Sensor Heater Monitor Bank 1 - Sensor 1	Heater exhaust gas sensor 1 - Bank 1
$42: Monitor-ID $42: Oxygen Sensor Heater Monitor Bank 1 - Sensor 2	Heater exhaust gas sensor 2 - Bank 2
$71: Monitor-ID $71: Secondary air injection system bank 1	Secondary air injection system bank 1
$A2: Monitor-ID $A2: Misfire Cylinder 1 Data	Misfire Cylinder 1 Data
$A3: Monitor-ID $A3: Misfire Cylinder 2 Data	Misfire Cylinder 2 Data
$A4: Monitor-ID $A4: Mis-Fire Cylinder 3 Data	Misfire Cylinder 3 Data
$A5: Monitor-ID $A5: Mis-Fire Cylinder 4 Data	Misfire Cylinder 4 Data