Overview - Crankshaft: Notes
NOTE:
Secure the engine to the assembly stand using the Engine and Gearbox Bracket:VAS6095A when performing the assembly work. Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .
- Cylinder Block
- Bearing Shell for Cylinder Block
- With lubricating groove
- Lubricate
- Do not interchange used bearing shells (mark)
- Crankshaft bearing shells identification (classification). Refer to MAIN BEARING SHELLS ALLOCATION .
- Crankshaft
- After removal, lay aside so that sensor wheel -item 8- OVERVIEW - CRANKSHAFT List Item:Sensor Wheel is not rested on and becomes damaged
- If the crankshaft is being replaced, then the bearing shells must be allocated to the bearing cover. Refer to MAIN BEARING SHELLS ALLOCATION .
- Axial clearance. Refer to CRANKSHAFT, MEASURING AXIAL CLEARANCE .
- Radial clearance. Refer to CRANKSHAFT, MEASURING RADIAL CLEARANCE .
- Do not turn crankshaft when measuring radial play
- Crankshaft dimensions. Refer to CRANKSHAFT DIMENSIONS .
- Bearing Shell for Bearing Cap
- Without lubricating groove
- Lubricate
- Do not interchange used bearing shells (mark)
- Crankshaft bearing shells identification (classification). Refer to MAIN BEARING SHELLS ALLOCATION .
- Bolt
- Replace after removing
- Tightening sequence. Refer to Crankshaft, Tightening Sequence
- Bearing Cap
- Bearing cap 1: belt pulley side
- Retaining tabs of bearing shells and cylinder block/bearing caps must lie above one another
- Bolt
- 10 Nm + 90°
- Replace after removing
- Replace sensor wheel every time bolts are loosened. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .
- Sensor Wheel
- For Engine Speed Sensor -G28-
- It is possible to install in one position only, the holes are offset.
- Replace sensor wheel every time bolts are loosened
- Removing and installing. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .
- Thrust Washers
- For bearing 3
- Lubricate
- Bolt
- Replace after removing
- Tightening sequence. Refer to chart below.