LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 50 (Gears & Shafts System (Service Information - 5-Speed Manual Transmission - 0AF)) >> 35 Gears, Shafts >> Output Shaft >> Output Shaft, Disassembling And Assembling >> Pressing Cylindrical Roller Bearing Into Cluth Housing

Pressing Cylindrical Roller Bearing Into Cluth Housing

WARNING: This page is about a different variant/trim than selected.
GWWA35-0035Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Support the clutch housing with the :VW415A  (not illustrated) directly below bearing mount.

-- Compress the cylindrical roller bearing locking ring -arrow- with pliers -A- and install it.

-- Remove the pliers before the cylindrical roller bearing gets into its installed position. The locking ring must lock into the groove on the clutch housing.

scientia non olet · About LEMON Manuals