LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 50 (Gears & Shafts System (Service Information - 5-Speed Manual Transmission - 0AF)) >> 35 Gears, Shafts >> Output Shaft >> Output Shaft, Disassembling And Assembling >> Installing The Locking Collar/Synchronizer Hub For 1ST & 2ND Gears

Installing The Locking Collar/Synchronizer Hub For 1ST & 2ND Gears

WARNING: This page is about a different variant/trim than selected.
GWWA35-0041Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installed position:

The shift fork groove in the locking collar faces 1st gear and the reverse gear splines face 2nd gear.

-- Turn the synchronizer ring so that the grooves line up with the locking pieces.

scientia non olet · About LEMON Manuals