The Cylinder Roller Bearing Inner Race Can Only Be Removed Separately With The Gear Wheel For The 4TH Gear

WARNING: This page is about a different variant/trim than selected.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the locking using the :VW161A .

-- Tension separating device -B- behind splines (not selector splines) on 4th gear.

A - Puller, for example, Puller - Kukko Puller - 60-150mm Width, 200mm Length :18/1

B - Puller, for example, Puller - Kukko Quick Action Separating Tool - 12-75mm :17/1

C - Protective Jaws

Fig 1: Exploded View Of Locking Collar And Synchronizer Hub For 3RD/4TH Gears

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Slide the locking collar over the synchronizer hub.

The deeper recesses -arrow A- for the locking pieces inside the synchronizer hub and the recesses -arrow B- inside the locking collar must align.