Install the Bearing Mount with Grooved Ball Bearing onto the Input and Output Shafts: Notes

Due to the varying spline height, the output shafts of individual transmissions have different -a- lengths (illustrated here with front shaft installed).

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

So that the bearing mount is always pressed in the same on the shafts, the shafts must always be inserted evenly in the :T10083  .

if necessary a :T10083/1  (3 mm thick) must be placed in the Input shaft locating bore. Refer to first figure in Pressing Bearing Mount .

For this reason the splines on the output shaft dimension -a- must be measured.