LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 50 (Gears & Shafts System (Service Information - 5-Speed Manual Transmission - 0AF)) >> 35 Gears, Shafts >> Input Shaft >> Input Shaft, Disassembling And Assembling >> Install the Bearing Mount with Grooved Ball Bearing onto the Input and Output Shafts >> Installing Stop Ring

Installing Stop Ring

WARNING: This page is about a different variant/trim than selected.
GWWA35-0032Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the stop ring onto the :2010  .

-- Insert stop ring together with :2010  into 5th gear synchronizer hub/locking collar (note installation location. Refer to Figure).

The hooks -arrow 1- engage in recesses -arrow 2- for synchronizer hub locking pieces.

-- Press stop ring down until the hooks engage.

scientia non olet · About LEMON Manuals