Camshaft Housing Tightening Specifications And Sequence
WARNING: This page is about a different variant/trim than selected.
 Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
|
-- Tighten the bolts in the steps shown in the sequence:
| Step |
Bolts |
Tightening Specification |
| 1 |
-1 through 18- |
Install by hand all the way
- The camshaft housing contact surface must lay entirely on top of the cylinder head
|
| 2 |
-1 through 18- |
8 Nm |
| 3 |
-1 through 18- |
90° additional turn |