Cylinder Head Tightening Specifications And Sequence

WARNING: This page is about a different variant/trim than selected.

Fig 1: Cylinder Head Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

-- Tighten the bolts in the steps shown in the sequence:

Step	Bolts	Tightening Specification/Additional Turn
1	-1 through 10-	30 Nm
2	-1 through 10-	65 Nm
3	-1 through 10-	90° additional turn
4	-1 through 10-	90° additional turn