Overview - Cylinder Head Cover: Notes
WARNING: This page is about a different variant/trim than selected.
- Seal
- Replace if damaged or leaking
- Cylinder Head Cover
- Removing and installing. Refer to CYLINDER HEAD COVER, REMOVING AND INSTALLING .
- O-ring
- Replace after removing.
- Plugs
- Bracket
- For wires
- Bolt
- 8 Nm
- Grommet
- In the cylinder head cover
- Tensioning Claw
- Bolt
- Tightening specification. Refer to OVERVIEW - FUEL INJECTORS
- O-ring
- Replace after removing.
- Hose
- For the crankcase ventilation
- For removal, press the release button
- Fuel Return Line
- O-ring
- Replace after removing.
- Fuel Injector
- Overview. Refer to OVERVIEW - FUEL INJECTORS .
- O-ring
- Replace after removing.
- Heat Protection Seal
- Replace after removing.
- Seal
- Replace after removing. Refer to FUEL INJECTOR SEALS, REMOVING AND INSTALLING .
- For the fuel injector
- Vacuum Hose
- Cap
- Seal
- For the cap
- Grommet
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Replace if the seal is damaged