Fuel Injector Seals, Removing And Installing: Procedure

WARNING: This page is about a different variant/trim than selected.

-- Remove the corresponding fuel injector. Refer to OVERVIEW - FUEL INJECTORS .

-- Install the :T40195 into the gasket -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Attach the :T10133/3 to the seal puller with the :T10133/2 as shown in the illustration and remove it by tapping it upward.

-- Install the new fuel injector seal with the :3390 and short extension -1- all the way and from above.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.