Overview - Clutch Hydraulics, RHD
WARNING: This page is about a different variant/trim than selected.
- Brake Fluid Reservoir
- Seal
- For the plastic supply hose
- The gaskets must be inside the supply hose.
- Supply Hose
- Made of plastic. Refer to Brake Booster Supply Hose .
- Clutch Master Cylinder
- Removing and Installing. Refer to CLUTCH MASTER CYLINDER, REMOVING AND INSTALLING .
- Clamp
- To remove and install the line, remove the clip up to the stop
- On some clutch master cylinders, it is pulled out on the side
- Seal/O-ring
- Install on the line connection
- Install with brake fluid
- Seals/O-rings suitable for the line connection material. Refer to Seals/ O-ring For The Hose/Line Assembly .
- For allocation refer to the Parts information.
- Base plate
- To remove and install, disconnect the clutch master cylinder from the clutch pedal. Refer to CLUTCH PEDAL, REMOVING AND INSTALLING .
- Clutch Pedal
- Removing and Installing. Refer to CLUTCH PEDAL, REMOVING AND INSTALLING .
- Nut
- Information and tightening specification: -item ) OVERVIEW - PEDAL ASSEMBLY - Nut.
- Bracket
- Attached to the body
- Hose/Line Assembly
- For allocation refer to the Parts information.
- To remove, remove the battery and battery tray. Refer to BATTERY .
- Bracket
- Secured on the ABS/EDL bracket
- Bracket
- for ABS/EDL
- Seal/O-ring
- Install on the line connection
- Install with brake fluid
- Seals/O-rings suitable for the line connection material. Refer to Seals/ O-ring For The Hose/Line Assembly .
- For allocation refer to the Parts information.
- Clamp
- The clamp must be removed in order to remove/install the hose/line assembly
- Clutch Slave Cylinder
- Removing and Installing. Refer to CLUTCH SLAVE CYLINDER, REMOVING AND INSTALLING .
- Bleed Valve
- Bleed clutch mechanism. Refer to CLUTCH MECHANISM, BLEEDING .
- Dust Cap
- Transmission
- Hex bolt
- Tightening specification: -item ) OVERVIEW - CLUTCH RELEASE MECHANISM - Hex Bolt
- Bracket