Mounting Bracket, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

NOTE:

Replace the self-locking nuts.

Replace the hose clamps

Allocate all components according to the Parts information.

Some vehicles have a damper -arrow- on the mounting bracket/clutch pedal.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Vehicles Without Knee Airbag

There are different ways of securing the impact bolster -1- in front of the clutch pedal -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Securing With Two Bolts

-- Install the crash bolster -1- and tighten the 2 bolts to the tightening specification.

Securing With One Bolt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the crash bolster -1- and tighten the bolt -2- to the tightening specification.

Continuation For All

-- Attach the cable guide -2- to the steering column.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the footwell vent -3-. Refer to A/C COMPRESSOR .

Vehicles With A Knee Airbag

-- Install the knee airbag bracket and crash bolster.

Continuation For All

-- Install the trim and the cover under the trim on the driver side. Refer to STORAGE COMPARTMENTS AND COVERS .

-- Press the hose/line assembly or plastic line -1- into the master cylinder connection -4- with the new seal -2- until the securing clip -3- audibly locks into place.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull on the line to make sure it is secure.

-- After removing the Hose Clamps - Up To 25mm :3094 bring the return hose back to its original shape.

-- Bleed the clutch mechanism. Refer to CLUTCH MECHANISM, BLEEDING .

-- Install the battery. Refer to BATTERY .

-- Install the air filter housing if it was removed earlier. Refer to AIR FILTER (CNLA, CRJA) , AIR FILTER (CZCA, CZDA, CZTA) , AIR FILTER (CBPA, CKJA) and AIR FILTER (CPLA, CPPA, CPKA, CPRA) .