LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 43 (Clutch System (Service Information - 5-Speed Manual Transmission - 0AF)) >> 30 Clutch >> Clutch Mechanism >> Clutch Release Mechanism, Servicing >> Removing and Installing the Release Bearing

Removing and Installing the Release Bearing

WARNING: This page is about a different variant/trim than selected.
GWWA30-0068Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the clutch release lever with the release bearing and guide sleeve. Refer to Clutch Release Lever -A- With Release Bearing & Guide Sleeve .

-- Press the tabs -arrows- together on backside of clutch release lever and remove release bearing -A- out of clutch release lever.

-- To install, press the release bearing -A- into the clutch release lever until the tabs -arrows- engage.

-- Grease the clutch release lever contact surfaces on the ball stud using Grease for Clutch Disc Shaft Splines.

-- Install the clutch release lever with the release bearing and guide sleeve. Refer to Clutch Release Lever -A- With Release Bearing & Guide Sleeve .

scientia non olet · About LEMON Manuals