Clutch Position Sensor -G476-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

NOTE:

Allocate all components according to the Parts information.

If The Hose/Line Assembly Or Plastic Line Was Removed:

-- Press the hose/line assembly or plastic line -1- into the master cylinder connection -4- with the new seal -2- until the securing clip -3- audibly locks into place.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull on the hose/line assembly or plastic line to make sure it is secure.

-- After removing the Hose Clamps - Up To 25mm :3094 bring the return hose back to its original shape.

-- Bleed the clutch mechanism. Refer to CLUTCH MECHANISM, BLEEDING .

-- Install the battery tray and the battery. Refer to BATTERY .

-- Install the air filter housing if it was removed earlier. Refer to AIR FILTER (CNLA, CRJA) , AIR FILTER (CZCA, CZDA, CZTA) , AIR FILTER (CBPA, CKJA) and AIR FILTER (CPLA, CPPA, CPKA, CPRA) .

-- Connect the battery and follow the procedure regarding what to do after connecting a battery. Refer to BATTERY .