Clutch, Removing And Installing, With Dual Mass Flywheel, LUK: Notes
WARNING: This page is about a different variant/trim than selected.
Special Tools And Workshop Equipment Required
- Flywheel Retainer :3067
- Alignment Tool - Clutch Plate :T10097
- Torque Wrench 1331 5-50Nm :VAG1331
- Grease for Clutch Disc Shaft Splines :G 000 100
- On engines which have a crankshaft with a smaller diameter, or engines with a needle bearing in the crankshaft -. Refer to the first figure in Centering Clutch Plate Centering Pin :3176 .