Throttle Valve Control Module -J338-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

Replace seals, and O-ring after removing.

-- When installing the intake tube with the Throttle Valve Control Module -J338-, pay attention to the alignment pins.

-- Install the upper front coolant pipes. Refer to OVERVIEW - COOLANT PIPES .

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .