Overview - High Pressure Reservoir (Rail)
WARNING: This page is about a different variant/trim than selected.
- Fuel Pressure Sensor -G247-
- 100 Nm
- Removing and installing. Refer to Fuel Pressure Sensor -G247-, REMOVING AND INSTALLING .
- Reuse is possible. Refer to INSTALLING - Check For Damage On The Sealing Surfaces (Biting Edge Seal) And Threads On The Fuel Pressure Sensor -G247-. If The Fuel Pressure Sensor -G247- Is Ok After Checking It, It May Be Reused .
- High Pressure Line
- 28 Nm
- Between the high pressure reservoir and the fuel injectors
- Read and follow all instructions on installing the high pressure lines. Refer to HIGH PRESSURE LINE, INSTALLING .
- High Pressure Reservoir (Rail)
- Removing and installing. Refer to HIGH PRESSURE RESERVOIR (RAIL), REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- O-ring
- Replace after removing.
- Fuel Pressure Regulator Valve -N276-
- 80 Nm
- Always replace if removed
- Removing and installing. Refer to Fuel Pressure Regulator Valve -N276-, REMOVING AND INSTALLING .
- After replacing adapt the adaptation values in "Guided Functions " using the Vehicle Diagnostic Tester.
- Fuel Return Hose
- Fuel Return Line
- Bolt
- 8 Nm
- High Pressure Line
- 28 Nm
- Between the high pressure pump and the high pressure reservoir
- Read and follow all instructions on installing the high pressure lines. Refer to HIGH PRESSURE LINE, INSTALLING .
- Bolt
- 8 Nm