Overview - Shift Unit
WARNING: This page is about a different variant/trim than selected.
- Bearing Bushing
- For the selector shaft
- Removing and Installing. Refer to OVERVIEW - TRANSMISSION HOUSING .
- Gearshift Unit
- Consisting of the gearshift shaft and the gearshift cover
- The components cannot be separated from each other
- Can be removed and installed with the transmission installed
- O-Ring
- Insert in the groove in the shift cover
- Install with transmission fluid
- Replace after removing
- Cap
- For the transmission ventilation
- Bolt
- For the shift unit to the transmission housing
- Tightening specification. Refer to OVERVIEW - TRANSMISSION HOUSING AND SELECTOR MECHANISM .
- Replace after removing
- Gearshift Shaft Seal
- Replacing. Refer to SELECTOR SHAFT SEAL, REPLACING .