LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2015 >> Jetta S, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Gears & Shafts System (Service Information - Manual Transmission - 02Q, 02QA)) >> 35 Gears, Shafts >> Output Shaft >> Output Shaft, Disassembling And Assembling >> Output Shaft, 1ST To 4TH Gears, Disassembling And Assembling >> Installing Tapered Roller Bearing Into Transmission Housing

Installing Tapered Roller Bearing Into Transmission Housing

WARNING: This page is about a different variant/trim than selected.
GWWN35-0239Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the adjusting shim under the outer race.

-- Support the transmission housing under the bearing mount using the Slide Hammer - Press Plate :2050  .

Disassembling the Output Shaft 

NOTE:

Remove the inner race/tapered roller bearing on the side of the transmission housing. Refer to Removing Inner Race/Tapered Roller Bearing .

scientia non olet · About LEMON Manuals