Removing Inner Race/Tapered Roller Bearing

WARNING: This page is about a different variant/trim than selected.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A - Puller - Quick Action Separating Tool - 22-115mm, for example :Kukko 17/2 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Note the following before installing the Tapered Roller Bearing Puller:

-- Remove the inner race/tapered roller bearing locking ring on the side facing the transmission housing.

-- Place the Press Piece - Multiple Use :VW431 in the output shaft and place the Press Piece - Multiple Use : 40-105 on top.