Output Shaft 1ST Through 4TH Gear, Adjusting: Notes

Special Tools And Workshop Equipment Required 

• Transmission Support :VW353 
• Dial Gauge Holder :VW387 
• Press Piece - Rod :VW407 
• Press Piece - Multiple Use :VW433 
• Seal Installer - Stator :VW792 
• Crankshaft Holding Fixture :VW801 
• Holding Plate :VW309A 
• Slide Hammer - Press Plate :2050 
• Torque Wrench 1331 5-50Nm :VAG1331 
• -1- Puller - Kukko Internal - 46-56mm :Kukko 21/7 
• -4- Puller - Kukko Counterstay :Kukko 22/2 
• Dial Indicator :VAS6080A 

(Selecting the correct adjusting shim for the output shaft)

It is necessary to adjust the output shaft if the following components were replaced:

• Transmission Housing
• Clutch Housing
• Output shaft for 1st to 4th gears or
• Output shaft tapered roller bearing

Adjustment overview. Refer to ADJUSTMENT OVERVIEW .