Oil Pan Upper Section, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

NOTE:

Be sure to check the expiration date of the silicone sealant.

The oil pan upper section must be installed within five minutes of applying the silicone sealant.

Replace the bolts that were tightened with an additional turn.

Replace the gaskets, seals and self-locking nuts.

-- Remove any sealant residue on the cylinder block using a flat blade scraper.

CAUTION:

Risk of injuring the eyes from sealant residue.

Wear protective eyewear.

-- Remove any remaining sealant on oil pan upper section using, for example, a rotating plastic brush.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

See if the timing chain cover is deformed. Then mount the oil pan upper section without any sealant and check the gap between the cover and the oil pan upper section. If deformation is found and the cover cannot be aligned, replace the cover after installing the oil pan upper section.

-- Sealing surfaces must be free of oil and grease.

-- Check for dirt in the oil passages in the oil pan upper section and in the crankshaft housing.

-- Cut the tube nozzle at the front marking (nozzle diameter: approximately 2 mm).

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

There is a risk that the lubrication system could be blocked by excess sealant. Do not apply sealant bead thicker than indicated.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Apply the silicone sealant on the clean sealing surface of the upper oil pan section as shown -arrows-.

Sealant bead thickness: 2 to 3 mm.

-- Apply the silicone sealant between the cylinder block and the lower timing chain cover as shown -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

The oil pan upper section must be installed within five minutes after applying the silicone sealant.

The sealant bead may not be thicker than specified, otherwise excess sealant could enter the oil pan and clog the oil intake pipe screen.

On the transmission side, the oil pan upper section and the crankcase must align.

-- Position the upper section of the oil pan immediately and tighten the bolts, tightening sequence. Refer to Figure.

-- Install the bolts -arrows-. Tightening specifications, refer to -item 13) OVERVIEW - TIMING CHAIN COVER - Bolt -

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the sealing flange on the transmission side. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE

-- Install the oil pump. Refer to OIL PUMP, REMOVING AND INSTALLING .

-- Insert the new oil baffle and secure it.

-- Install the oil pan lower section. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .

Further assembly is performed in the reverse order of the removal.

-- Fill the engine oil and check the oil level.