Overview - Belt Pulley Side Sealing Flange: Notes
WARNING: This page is about a different car, the 2018 Volkswagen Jetta, 2017 Volkswagen Jetta, and 2016 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 150 Nm +180°
- Replace after removing.
- Vibration Damper
- Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
- Seal
- Replace after removing. Refer to CRANKSHAFT SEAL, REPLACING, BELT PULLEY SIDE .
- For the belt pulley side crankshaft
- Do not oil
- Sealing Flange, Belt Pulley Side
- Must be seated on the alignment pins
- Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .
- Bolt
- Tightening specification and sequence. Refer to Ribbed Belt Pulley Side Sealing Flange Tightening Specifications And Sequence .
- Replace after removing.
- There are different thread diameters.
- Seal
- Replace after removing.
- Cylinder Block
- Alignment Pin
- Quantity: 2
- Bolt
- Tightening specification and sequence. Refer to Ribbed Belt Pulley Side Sealing Flange Tightening Specifications And Sequence .
- Replace after removing.