Ribbed Belt, Removing And Installing

WARNING: This page is about a different car, the 2014 Volkswagen Jetta, 2013 Volkswagen Jetta, 2012 Volkswagen Jetta, and 2011 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Locking Pin T10060A

Removing

-- Remove the noise insulation, refer to NOISE INSULATION AND FOAM PIECES, FENDER AND FENDER END PLATE .

CAUTION:

Risk of destroying due to reversed running direction on a used ribbed belt.

If the ribbed belt is going to be installed again, mark the running direction with chalk or a marker.

-- Move the tensioner in direction of -arrow- to release the tension on the ribbed belt.

Fig 1: Identifying Method To Relieve Tension On Poly V-Belt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure the tensioner with Locking Pin T10060A.

Fig 2: Identifying Lock Tensioner With Locking Pin T10060 A

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the ribbed belt.

Installing

Install in reverse order of removal. Note the following:

NOTE:

Make sure all assemblies (generator, Air Conditioning (A/C) compressor and power steering pump) are installed securely before installing the ribbed belt.

Make sure the running direction of the ribbed belt is correct and that the belt is routed correctly over the belt pulley.

Route the ribbed belt last over the generator on vehicles without an A/C system.

Route the ribbed belt last over the A/C compressor on vehicles without an A/C system.

After the work is completed:

-- Start the engine and check the belt running.

Belt drive without A/C compressor

Fig 3: Identifying Belt Drive For Vehicles Without Air Conditioning

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Belt drive with A/C compressor

Fig 4: Identifying Belt Drive For Vehicles With Air Conditioning

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.