Removal And Installation: Radiator

WARNING: This page is about a different car, the 2010 Volkswagen Jetta and 2009 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Refractometer T10007
Torque Wrench (5-60 Nm) V.A.G 1783
Drip Tray for VAS 6100 VAS 6208

Removing

-- Move the lock carrier into the service position. Refer to Description and Operation .

-- Drain the coolant. Refer to DRAINING AND FILLING .

-- Remove the upper coolant hose clamp and remove the coolant hose from the radiator quick-release coupling.

-- Disconnect the connector for the fans.

-- Remove the radiator bolts -item 10- in COOLING SYSTEM COMPONENT OVERVIEW, BODY SIDE and remove the radiator upward with the fans.

Installing

Install in reverse order of removal. When doing this note the following:

Radiator bolt tightening specification, see -item 10- in the COOLING SYSTEM COMPONENT OVERVIEW, BODY SIDE .

-- Fill with coolant. Refer to DRAINING AND FILLING .