Multifunction Transmission Range Switch -F125-: Adjusting

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen Golf, 2008 Volkswagen Jetta, and 2008 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the selector lever into the "N" position.

-- Do not bend the selector lever cable.

Adjustment Prerequisites

Selector lever cable is disconnected at the selector shaft lever
The selector shaft is in the "N" position.
The bolts on the multifunction switch have been loosened.
The lever/selector shaft is removed.

Perform the following procedure:

-- Install the T10173 on the selector shaft -2- and turn the multifunction switch -1- just until the T10173 locks onto the tab on the connector on the multifunction switch.

Fig 1: Identifying Adjustment Tool Attached Onto Shift Rod

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Use the bolt -3- to secure the T10173 to the selector shaft -2-.

-- Tighten the bolts -arrows- to 6 Nm.

-- Remove the T10173.

-- Further installation is performed in the reverse sequence, refer to Installing .