Multifunction Transmission Range Switch -F125-: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen Golf, 2008 Volkswagen Jetta, and 2008 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal.

-- Attach the lever -4- to the selector shaft -6-.

Fig 1: Identifying Selector Shaft Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the bolts -5- for the multifunction switch hand tight.

-- Bend back the hooks on the lock washer -2-.

-- Install the washers -2 and 3- on the selector shaft -6-.

-- Install the washer -2- with the hooks facing up.

-- Install the washer -2- with the long narrow guide into the long narrow depressions in the selector shaft -6-.

-- Tighten the nut -1- to 7 Nm.

-- Tighten the nut -1- and secure it by bending the hook on the washer -2- upward.

-- Replace the lock washer is a hook breaks off.

-- Attach the lever -3- to the selector shaft -4-.

Fig 2: Identifying Selector Shaft Lever Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Move the selector lever -3- into the "P" position. This means, push the selector lever -3- opposite the drive direction until it stops.

-- Move the lever -3- into the "N" position. Push the lever -3- two position forward in the direction of travel.

-- Mount the spring washer -2- and the nut -1- on the selector shaft -4-.

-- Tighten the nut -1- to 13 Nm.

-- Selector mechanism, checking. Refer to SELECTOR MECHANISM THROUGH 02.2009, CHECKING .