Noise Generator Overview

NOTE:

Charge Air Pipe from the noise generator removing and installing. Refer to CHARGE AIR PIPE FROM NOISE GENERATOR .

The noise generator is not installed on all vehicles. As of 04.09, the noise generator is replaced by the structure-borne sound actuator -R214-. Refer to Structure-Borne Sound Actuator -R214- AND Structure-Borne Sound Control Module -J869- OVERVIEW .

Fig 1: Identifying Assembly Overview: Noise Booster, Rabbit/GTI

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Cover
Bolt
- 8 Nm
Plenum Chamber Bulkhead
Hood
- For the duct to the plenum chamber bulkhead.
Charge Air Pipe
- Connecting and disconnecting, refer to CHARGE AIR HOSE AND PIPE, DISCONNECTING AND CONNECTING .
Hose Clamp
Charge Air Hose
Bolt
- 8 Nm
Spacer Sleeve
Rubber Bushing
Noise Generator
- Before removal, remove the cover, refer to "Cover" in item: 1.
Bracket
- For the noise generator.
Nut
- 8 Nm