Reverse Shaft: Notes
WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Thrust Tube VW 454
- Thrust Pad VW 447 H
- Punch VW 411
- Centering Mandrel 12 - 551
- Thrust Place VW 401
- Punch VW 408 A
- Kukko Extractor 14.5-18.5 mm 21/2
- Kukko Support 22/1
NOTE:
Always replace the needle sleeve after removing it from the clutch housing or from the reverse shaft support.
- Clutch Housing
- Needle Sleeve
- Removing, refer to Removing the Needle Sleeve from the Clutch Housing .
- Installing, refer to Installing the Needle Sleeve -A- into the Clutch Housing .
- Reverse Gear
- Lock Ring
- Always replace after removing.
- Reverse Gear
- Remove before replacing the lock ring.
- Collar faces reverse gear.
- Reverse Shaft
- Removing, refer to TRANSMISSION .
- Needle Sleeve
- Removing, refer to Removing the Needle Sleeve from the Clutch Housing .
- Installing, refer to Installing the Needle Sleeve into the Reverse Shaft Support .
- Reverse Shaft Support
- Removing and installing, refer to TRANSMISSION .