LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2008 >> R32 >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Gears, Shafts - 5-Speed Manual Transmission 0A4 (As Of 04.2010)) >> 35 Gears, Shafts >> Disassembly And Assembly >> Reverse Shaft >> Removing the Needle Sleeve from the Clutch Housing

Removing the Needle Sleeve from the Clutch Housing

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Pulling Needle Bearing Out Of Clutch Housing
GWWV35-1152Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A -

Counter-support, for example, 22/1

B -

Internal puller 14.5 to 18.5 mm, for example, 21/2

NOTE:

The needle sleeve will get damaged when it removed and must be replaced.

scientia non olet · About LEMON Manuals