Disassembling and Assembling Locking Collar and Synchronizer Hub for 3rd/4th Gears

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disassembling And Assembling 1St And 2Nd As Well As 3Rd And 4Th Gear Locking Collar And Synchro-Hub

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1 -

Spring

Assembly in conjunction with the hollow locking pieces, refer to Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th Gears together with Locking Pieces that are not Hollow .

Assembly in conjunction with locking pieces that are not hollow, refer to Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th Gears together with Locking Pieces that are Hollow on the Inside .

2 -

Locking piece

3 -

Locking collar

4 -

Synchronizer hub

-- Slide the locking collar over the synchronizer hub.

The notches for the locking pieces on the synchronizer hub and locking collar must line up with each other.