LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2008 >> R32 >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Gears, Shafts - 5-Speed Manual Transmission 0A4 (As Of 04.2010)) >> 35 Gears, Shafts >> Disassembly And Assembly >> Output Shaft >> Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th Gears together with Locking Pieces that are Hollow on the Inside

Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th Gears together with Locking Pieces that are Hollow on the Inside

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Assembling 1St And 2Nd As Well As 3Rd And 4Th Gear Locking Collar/Synchro-Hub
GWWV35-0981Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The locking collar is pushed over the synchronizer hub.

-- Install the locking pieces and springs offset by 120°. The angled end of the spring must engage into the hollow locking piece.

scientia non olet · About LEMON Manuals