Retainer And Power Seat Bracket

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Removal and installation is described for left seat. The same instructions apply for removal and installation for the right seat.

Removal

-- Turn off the ignition.

-- Remove left power seat trim. Refer to POWER SEAT TRIM, LEFT .

-- Remove bolts -1- (3.5 Nm) and remove bracket -2- from seat frame.

-- Remove two bolts -3- (3.5 Nm) and remove bracket -4- and spacer pipe -5- from seat frame.

Fig 1: Identifying Retainer And Power Seat Bracket Remove/Install Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installation

-- To install, perform the steps used for removal in reverse order.