Right Flange Shaft Seal, Outside Of Bevel Box

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Removing

The seal can be replaced with the transmission installed.

-- Remove the right flange shaft. Refer to RIGHT FLANGE SHAFT, AWD .

-- Pry the seal out of the flange shaft with a lever.

Installing

-- Install the new seal using the thrust piece -T10049-.

Fig 1: Identifying New Sealing Ring Drived In To Stop Using Thrust Piece T10049

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Fill the area between the sealing lip and dust lip -arrow- halfway with sealing grease for seal -G 052 128 A1-.

Fig 2: Identifying Oil Seals Sealing Lips

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Install the right flange shaft. Refer to RIGHT FLANGE SHAFT, AWD .

-- Check the oil level in the bevel box and fill, as necessary. Refer to BEVEL BOX GEAR OIL LEVEL, CHECKING AND FILLING .