EVAP System Overview
WARNING: This page is about a different variant/trim than selected.
- Separating Point
- In the right front of the engine compartment, under the coolant expansion tank.
- Vent Line
- White or with a white mark.
- From the Evaporative Emission (EVAP) canister to the EVAP canister purge regulator valve 1.
- Installed position: On the right side of the underbody.
- Attached to the fuel tank.
- Vent Line
- Green or with a green mark.
- From the engine to the leak detection pump.
- Installed position: On the right side of the underbody.
- Attached to the fuel tank.
- Separating Point
- On the right front side of the fuel tank, near the fuel filter.
- Filler Tube
- Vent Line
- From the filler tube to the EVAP canister.
- Air Filter
- For the leak detection pump.
- Leak Detection Pump -V144-
- Installed location: Under the right rear wheel housing liner.
- Removing and installing, refer to Leak Detection Pump -V144- .
- Fuel system, checking for leaks. Refer to FUEL SYSTEM, CHECKING FOR LEAKS .
- Connecting Line
- From the leak detection pump to the EVAP canister.
- Attached to a bracket.
- EVAP Canister
- Installed location: On the bottom of the spare tire wheel well.
- Removing and installing, refer to EVAP CANISTER .
- Separating Point
- On the right back side of the fuel tank.
- Turbocharger
- Brake Booster
- Vacuum Pump
- Check Valve
- Installed position: Arrow points in the direction of flow.
- EVAP Canister Purge Regulator Valve 1 -N80-
- Checking, refer to the vehicle diagnosis, testing and information system VAS 5051.
- Double Check-Valve
- Checking, refer to DOUBLE CHECK-VALVE, CHECKING .
- Throttle Calve Control Module -J338-
Removing and installing, refer to Throttle Valve Control Module -J338- .
- Intake Manifold