Main Fuse Box
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Torque Wrench V.A.G 1331
Main fuse box is located at rear right of luggage compartment under tool kit and wagon jack formed insert.
WARNING:
- Observe safety precautions when working on battery isolation system. Refer to BATTERY INTERRUPT IGNITER -N253-, SAFETY PRECAUTIONS .
- Observe notes for disposal of battery isolator units. Refer to BATTERY INTERRUPT IGNITER DISPOSAL .
Removing
-- Remove Battery Interrupt Igniter -N253-. Refer to BATTERY INTERRUPT IGNITER -N253- .
-- Remove nuts -1-, -2- and -3- and remove wires from connector threads.
-- Pull harness connector -4- out of its secured position in main fuse box.
-- Pull the locking lever -2- outward in the direction of the arrow and disconnect the connector -1-.
-- Remove both nuts -arrows- and remove main fuse box -1- from vehicle.
Installing
Install in reverse order of removal. Note the following:
-- Tighten all threaded connections to specified torque. Refer to TIGHTENING SPECIFICATIONS, MAIN FUSE BOX .