Contacts In Contact Housing, Repairing

WARNING: This page is about a different variant/trim than selected.

-- First, open or release if necessary the secondary lock of the contact housing. Refer to SECONDARY LOCK .

-- Release contact (primary lock) using the appropriate release tool. Refer to PRIMARY LOCK .

Fig 1: Identifying Use Of Release Tool On Primary Terminal Lock

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Pull contact at single wire out of contact housing.

-- Take the yellow repair wire with the correct contact out of the Wiring Harness Repair Set.

-- Free up repair point of vehicle-specific wiring harness (approximately 20 cm to both sides of repair point).

-- If required, remove wiring harness wrapping using a folding knife.

-- Insert new contact of repair wire into contact housing until it engages.

Fig 2: Identifying Procedure To Insert New Terminal

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Slide a single wire seal onto the repair wire.

NOTE:

When doing this, small diameter of single seal must point toward contact housing.

-- Slide single wire seal into contact housing using the correct assembly tool. Refer to SINGLE WIRE SEALS, INSTALLING .

-- Shorten the repair wire and the vehicle-specific wiring harness single wire as needed using the Wire Stripper -VAS 1978/3-.

Fig 3: Identifying Wire Stripper To Cut Wire

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Strip ends of repair wire and of vehicle-specific single wire using 6 - 7 mm wire stripper.

Fig 4: Identifying Stripping Pliers To Strip Wiring Insulation

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Crimp the stripped ends of repair wire and single wire of vehicle-specific wiring harness using crimp pliers and a crimp connection as described in WIRE BREAK WITH SINGLE REPAIR POINT .

NOTE:

Make sure that crimp connections do not lie directly next to each other when several wires need to be repaired. Arrange the crimp connectors at a slight offset so that the circumference of the wiring harness does not become too large.

Fig 5: Identifying Offset Positions Of Crimped Connections

Courtesy of VOLKSWAGEN UNITED STATES, INC.

In the event the repair point was previous taped, this point must be taped anew with yellow insulating tape after repairs.

Secure the repaired wiring harness if necessary with a cable tie to prevent flapping noises while driving.