Vehicle Diagnosis, Testing And Information Systems
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
- Diagnostic Cable -VAS 5051/6A- (5 m)
- Diagnostic Cable -VAS 5051/5A- (3 m)
- During road tests using a vehicle diagnostic and information system, there is the hazard of extreme to lethal injuries.
- If vehicle diagnostic and information system is deposited in the action area of an airbag during a road test, here is the hazard of extreme to lethal injuries in the event the airbag deploys.
- During road tests, have a person sitting in the rear seat to operate the vehicle diagnostic and information system.
All of the procedures described such as adaptations and coding can be performed with the Vehicle Diagnostic Tester.
All work instructions can be reached in the operating modes "Guided Fault Finding" and "Guided Functions".
Additional information:
Self Study Program No. 202; Vehicle Diagnosis, Testing and Information System -VAS 5051-
Self Study Program No. 256; -VAS 5052-
Self Study Program No. 294; On-line connection of -VAS 5051-
-- Connect the Vehicle Diagnostic Tester, refer to Procedure .
Follow the current operating instructions for the vehicle diagnosis, testing and information system, which can be displayed by selecting the "Administration" and "operator's handbook" buttons.
For the diagnostic, only the diagnostic cables listed above are to be used since only these are equipped with CAN wires and permit a CAN diagnostic or CAN communication.