General Information: Procedure
WARNING: This page is about a different variant/trim than selected.
-- Apply the parking brake.
-- In vehicles with automatic transmission, move the selector lever to the "P" or "N" position.
-- In vehicles with manual transmissions, move the shift lever to the neutral position.
-- With the ignition switched off, connect the Vehicle Diagnostic Tester with the diagnostic cable -VAS 5051/6A- to the data link connector in the vehicle -arrow-.
-- Switch on ignition.
-- Turn off all electrical consumers.
NOTE:
The connection of all other Vehicle Diagnostic Tester and the following diagnostic operation system or vehicle diagnosis and service system occurs in the previously described sequence.