LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2006 >> GTI 1.8 E, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (2.0L - Crankshaft, Cylinder Block - Engine Code(S): BPY) >> 13 Crankshaft, Cylinder Block >> Description And Operation >> Engine Overviews >> Ribbed Belt And Accessory Drive

Ribbed Belt And Accessory Drive

WARNING: This page is about a different variant/trim than selected.
Fig 1: Engine Assembly Overview Part I
GWWN13-10148Courtesy of VOLKSWAGEN UNITED STATES, INC.
  1. Accessory Bracket
    • Follow the tightening sequence, refer to Fig 2.
  2. Bolt
    • 23 Nm
  3. Nut
    • 23 Nm
  4. Generator
    • Removing and installing, refer to Removal and Installation .
    • Moving the threaded bushings on the generator slightly to the rear will make is easier to install the generator.
  5. Bolt
    • 40 Nm
    • Follow the tightening sequence, refer to Fig 2.
  6. Bushing
    • Quantity: 2
  7. Bolt
    • 25 Nm
  8. Air Conditioning (A/C) Compressor
  9. Ribbed Belt
    • Mark the rotation direction with chalk or a felt-tip pen before removing.
    • Check for wear.
    • Do not kink.
    • Removing and installing, refer to RIBBED BELT .
  10. Vibration Damper
    • With the pulley for the ribbed belt.
  11. Bolt
    • 20 Nm + 90° (1/4) additional turn.
    • Always replace.
  12. Bolt
    • 23 Nm
  13. Belt Tensioner
    • Rotate the tensioner using a open end wrench to release the tension on the ribbed belt.
Fig 2: Accessory Assembly Bracket Tightening Sequence
GWWN13-10043Courtesy of VOLKSWAGEN UNITED STATES, INC.
scientia non olet · About LEMON Manuals