Turbocharger Vacuum Diaphragm

WARNING: This page is about a different variant/trim than selected.

Removing

-- Remove the turbocharger. Refer to TURBOCHARGER .

-- Loosen the securing plate above the linkage on the turbocharger.

-- Loosen the lock nut -2-.

Fig 1: Identifying Lock Nut, Turbocharger, Vacuum Diaphragm

Courtesy of VOLKSWAGEN UNITED STATES, INC.

-- Disconnect the linkage from the turbocharger -3-.

-- Remove the vacuum diaphragm -1- bolts -arrows-.

Installing

Install in reverse order of removal. Note the following:

-- Adjust the vacuum diaphragm. Refer to TURBOCHARGER VACUUM DIAPHRAGM, ADJUSTING .

-- Install the turbocharger, refer to TURBOCHARGER .

Tightening Specifications

Component		Nm
Vacuum diaphragm to turbocharger		10