Ignition System, Servicing: Notes

WARNING: This page is about a different car, the 2008 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

The following table provides quick links to all instructions in this section.

SAFETY PRECAUTIONS .
SPARK PLUGS, TEST DATA .
CAMSHAFT POSITION SENSOR G40, CHECKING .
CAMSHAFT POSITION SENSOR 2 G163, CHECKING .
CAMSHAFT ADJUSTMENT VALVE 1 N205, CHECKING .
CAMSHAFT ADJUSTMENT VALVE 1 N318, CHECKING .
KNOCK SENSOR 1 G61, CHECKING .
KNOCK SENSOR 2 G66, CHECKING .
IGNITION COILS WITH POWER OUTPUT STAGE, CHECKING .

For all Ignition/Glow plug system component locations. Refer to DESCRIPTION AND OPERATION .

For all Ignition/Glow plug system removal/installation procedures and torque specifications. Refer to REMOVAL AND INSTALLATION .

NOTE:

All manufacturers special tools as well as common tools may contain a manufacturer specific part number. These tools may be substituted with an equivalent aftermarket tool or are available for purchase through VW.

Manufacturers special tools as well as common tools that contain a manufacturer specific part number may be referenced in the test procedure illustrations showing the tool use or installation. If the manufacturer specific tool is not being used, an equivalent aftermarket tool may be installed in the same manner as the manufacturers special tool.

The manufacturers test box Test Box 105 PinVAG1598/31 is available for purchase or rental.